Stats

  • State Suggested Answer
  • Replies 2
  • Answers 1
  • Subscribers 160
  • Views 10528
  • Members are here 0
More Content

Generating pin pairs for Match Group members

Fredda

I've been reading this tutorial on matched groups, but I can't get the Constraint Manager to create pin pairs. I thought they would just appear when setting the tolerance just like in this video at 2:26:

https://www.youtube.com/watch?v=x5XY0zQ0fZM

Or at least when right clicking the matched group and click Analyze. I've got it setup as below, but no pin pairs have been created.

Regards

F

Parents
  • steve
    0

    Are these nets routed yet? If not then go to Analyze - Analysis Modes and under Electrical turn on the two options for DRC unrouted then click OK and try and Analyze the group again.

  • Fredda
    0 in reply to steve

    The nets aren't routed, but I did have the options for DRC unrouted turned on. However, I didn't have the On-line DRC turned on. When turning on that option, the pairs are created as expected!

    By the way, those tutorials and videos are really great!

    Thanks.

    F.

Reply
  • Fredda
    0 in reply to steve

    The nets aren't routed, but I did have the options for DRC unrouted turned on. However, I didn't have the On-line DRC turned on. When turning on that option, the pairs are created as expected!

    By the way, those tutorials and videos are really great!

    Thanks.

    F.

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.