Stats

State Not Answered
Replies 9
Subscribers 162
Views 13092
Members are here 0

Deleting diff pairs in constraint manager

I have a pcb design where the pins in the previous version of this design were actually diff pairs. In the latest revision of this design, these pins have been changed to single type nets, not diff pairs anymore.

In the constraint manager I tried to delete the diff pair group but the delete button is greyed out. I tried unfixing the nets and symbols which are attached to these nets but still cannot delete them.

The nets are not considered diff pairs in the schematic.

I am using Allegro pcb editor 17.4

Thanks

Parents

0 Daniel over 3 years ago

if you want to delete all diff pairs quickly, you can use code below:

command: skill > axlDiffPair(axlDBGetDesign()->diffpair)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Daniel over 3 years ago

if you want to delete all diff pairs quickly, you can use code below:

command: skill > axlDiffPair(axlDBGetDesign()->diffpair)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.