• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Allegro X PCB Editor
  3. Can anybody guide me that how can I create a tool to check...

Stats

  • State Not Answered
  • Replies 1
  • Subscribers 160
  • Views 7392
  • Members are here 0
More Content

Can anybody guide me that how can I create a tool to check Copper blockage

smah
smah over 2 years ago

Hello Everyone,

I wanted to know that how can I check the copper blockage in the below snap its a GND layer and I wanted to create a tool to check the copper blockage.

If anyone can guide me I would be thankful to you.

  • Sign in to reply
  • Cancel
  • DavidJHutchins
    0 DavidJHutchins over 2 years ago

    Look at the topic 'How to measure minimum shape width?' for eDave's suggested method...

    • Cancel
    • Vote Up 0 Vote Down
    • Sign in to reply
    • Verify Answer
    • Cancel
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information