Stats

State Suggested Answer
Replies 2
Answers 1
Subscribers 160
Views 6592
Members are here 0

Move block with routing

Hi,
Is there a way we can move a selected block( selected components with tracks and vias) connected to them? So that we can retain the routing with net names when we move the selection to some other location in the same board.

Thank You

Parents

0 avant over 2 years ago

Sure, Select the move command. Set the find filter to Symbols, Clines, and Vias. Right click mouse and select Temp Group.

Select components, clines, and traces. Right mouse click, select Complete. Move group.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Reject Answer

Cancel

Reply

0 avant over 2 years ago

Sure, Select the move command. Set the find filter to Symbols, Clines, and Vias. Right click mouse and select Temp Group.

Select components, clines, and traces. Right mouse click, select Complete. Move group.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Reject Answer

Cancel

Children

0 Schulz Jordan over 2 years ago in reply to avant

The etch has to be set to stretch etch else the traces will rip by default
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.