Stats

More Content

As a fab company, if a solder mask file is received, it should be converted to "negative" profile before its used for film print?

dp09

Hi Team,

Check the below image of the solder mask layer. The red color pads and holes need not to be masked. 

If this same file is used for screen print it looks some thing like below image (in panel format) -

So in this case, the pads and holes will be masked and rest of the other area will be unmasked..Is this understanding correct.??

If yes, that means its negative should be generated from allegro and that file to be used for screen print.. right..??

Please share the response ASAP.

Thanks.

Parents
  • +1

    Hi Dp09, the soldermask is always provided in this negative image. Soldermask gerber always shows where we don't want mask. Historically this also reduced the file size on old machines. There is no need to provide data describing everywhere soldermask is needed, just where it isn't. This is the standard for sodlermask which producers understand, so there is no need to translate a negative soldermask image to positive for the producers. They understand this format better. So solder-paste gerber layers should be positive but soldermask should always be in negative format. 

    Totally agree with the info above regarding pull back on the board edge! We did this in automotive pcbs also. The soldermask should stop before the board edge so you should see a pcb outline on this layer by way of "negative soldermask". This technique helps the mask to remain healthy after the milling machine cuts out the pcbs. If we cut through the soldermask with the milling tool then we disturb its integrity which may lead to extra moisture intake or contamination at these edges.

Reply
  • +1

    Hi Dp09, the soldermask is always provided in this negative image. Soldermask gerber always shows where we don't want mask. Historically this also reduced the file size on old machines. There is no need to provide data describing everywhere soldermask is needed, just where it isn't. This is the standard for sodlermask which producers understand, so there is no need to translate a negative soldermask image to positive for the producers. They understand this format better. So solder-paste gerber layers should be positive but soldermask should always be in negative format. 

    Totally agree with the info above regarding pull back on the board edge! We did this in automotive pcbs also. The soldermask should stop before the board edge so you should see a pcb outline on this layer by way of "negative soldermask". This technique helps the mask to remain healthy after the milling machine cuts out the pcbs. If we cut through the soldermask with the milling tool then we disturb its integrity which may lead to extra moisture intake or contamination at these edges.

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.