• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Allegro X PCB Editor
  3. auto router question

Stats

  • State Suggested Answer
  • Replies 1
  • Answers 1
  • Subscribers 159
  • Views 5987
  • Members are here 0
More Content

auto router question

masamasa
masamasa over 2 years ago

hello.

 

i am trying to do some auto routing.

it works from the top layer to bottom layer.

but it does not work from top layer going to the next layer and comback to the top layer. 

is there any setup difference i need to make for the chip-to-chip interconnects?

 

regards

masa

  • Sign in to reply
  • Cancel
  • VVRD
    0 VVRD over 2 years ago

    Hi masa,

    Check all the routing subclass is turned on in Automatic Router window. Route -> PCB Router -> Route Automatic.

    Thank you.

    • Cancel
    • Vote Up +1 Vote Down
    • Sign in to reply
    • Verify Answer
    • Reject Answer
    • Cancel
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information