How to fillet a T junction in traces?

Question

In the past I know I've been able to target a specific T junction in a trace and fillet it, but I can't remember how I did it or figure out how to do it again. 
 So how do you fillet a T junction in a trace? 
 Thanks

masamasa · Answer

u can type add fillet on the command line or u can run the command from the menu; 
 
 route --> teardrop/tapered trace --> add teardrop

then u click the trace that u would like to add a fillet to.

please make sure that the t connections is "on" and the dynamic is "off" on the parameter settings.

the missing fillets report can tell us where t connections are missing.

Stats

How to fillet a T junction in traces?

Community Guidelines