Stats

State Suggested Answer
Replies 4
Answers 1
Subscribers 162
Views 5616
Members are here 0

Constrain manager Required and Actual Values

Hi All!

First time using Orcad Capture/PCB Editor here from Altium Design. I am trying to set up the CM and one of the DRCs I am dealing with now is same net spacing. In the example below, it's pin to thru via same net spacing. I have set in CM so that the Required is "0 mm" and it does reflect it. I have done DRC update but it doesn't do anything. Anything I'm missing here? note that the actual drill hole won't be hitting the pins. idk if that is relevant.

Many Thanks!

layout:

DRC:

Parents

0 jc teyssier over 1 year ago

The value for "no check es not "0" but "-1"

Be aware to use such value only in an area creted specilly for this.

Other solution: waive the drc and comment it to explain the decision
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 jc teyssier over 1 year ago

The value for "no check es not "0" but "-1"

Be aware to use such value only in an area creted specilly for this.

Other solution: waive the drc and comment it to explain the decision
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 TCHA over 1 year ago in reply to jc teyssier

@Norb15, can you provide an update on this?
Cancel
Vote Up +2 Vote Down

Sign in to reply

Verify Answer

Reject Answer

Cancel

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.