Stats

  • State Suggested Answer
  • Replies 13
  • Answers 1
  • Subscribers 160
  • Views 7911
  • Members are here 0
More Content

Nets in the PCB layout not respecting the spacing rules provided in the constraint manager

RohitRohan

When i am routing the nets in the PCB board i can see that the nets which i routing in the PCB board are not respecting the spacing rules provided in constraint manager. The 2 nets come close to each other normally they should shove, but in case the PCB board which i working, the 2 nets even though different net names when the nets come close to each other instead of shove the nets are overlapping to each to other. In analysis the spacing constraints are enabled but still the nets are overlapping with each other. May i know why the issue is occurring. I have run the DB Doctor also on the PCB file but same results. Currently i am using version 22.1 PCB editor.

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.