Stats

More Content

Create shape from lines comand

BB202506061452

I use Allegro 25.1

I imported a .dxf file and created a shape out of the imported lines (its a logo that I want to put on the board geometry sst layer). Then I switched to a different pcb to do the exact same thing with the exact same .dxf file and now the comand cant select anything. It worked just fine on my other pcb. I can also not select or unselect any option in the 'Desgin Object Find Filter' when the create shape from lines comand is active. Everything is greyed out. What is going on?

Parents
  • steve
    0

    Your probably not in any Application Mode. Try Setup - Application Modes - General and see if that helps.

Reply
  • steve
    0

    Your probably not in any Application Mode. Try Setup - Application Modes - General and see if that helps.

Children
  • BB202506061452
    0 in reply to steve

    I thought of that too, but in this case it isnt the issue sadly

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.