Stats

Replies 3
Subscribers 158
Views 3476
Members are here 0

Changing "Swap Code" For Pins in a Connector

Hi All,

I have a connector component where i would like to enable pin swapping to simplify routing. However when i try to swap pins, i get the message " Pin not swappable, swap code is zero. Pick again. "

So i was thinking, maybe if i could use skill to modify the swap code for the pins.

In the Allegro Skill Reference
Table 2-24 Function Pin Attributes
swap code | integer | Swap code of function pin

How do i write the code for this? or Is there a better solution

regards,
newbie

Originally posted in cdnusers.org by Newbie

Parents

archive over 20 years ago

I think newbie wanted to do it by a skill program in the database and not to go back to the schematics. This is very useful and I would be interested too in such a program.

Originally posted in cdnusers.org by pdidhi
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

archive over 20 years ago

I think newbie wanted to do it by a skill program in the database and not to go back to the schematics. This is very useful and I would be interested too in such a program.

Originally posted in cdnusers.org by pdidhi
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.