Using Skill to route clines?

Question

Is it possible to do basic routing with Skill? I want to be able to place a straight cline from a user defined point to the edge of an area (this would be part of a module so it's not necessarily board or design space edge). The idea is if my design area is 10000 x 10000 mils I click a via (500,500) and a cline is placed from that point to (10000, 500). I am not familiar with the language and don't want to devote resources to learning it if it can't do what I'm looking for. Is this something that could be done?

eDave · Accepted Answer

Yes. Such basic routing is as simple as a single command: 
 axlDBCreateLine(list( 500:500 1000:500), width, netname) 
 where width is the width and netname are variables.

Stats

Using Skill to route clines?

Community Guidelines