Differentiate drcs: Symbol Vs Design

Question

Hello All, 
 
 I have symbols in my library that were intentionally created to violate DRC rules. 
 
 After logic import, they are transferred to the layout editor, along with their DRCs. 
 
 The command axlDBGetDesign()->drcs gives me all the DRCs in the design. 
 
 Which SKILL commands or functions can differentiate between Symbol DRCs and Design DRCs? 
 
 Thank you very much in advance. 
 
 BR 
 Samba

andakConsultingLtd · Answer

Try the code below, it should give you a starting point. I am sorry, parent indeed didn't set you in the right direction. 
 ; the code below works in my case for a pin to pin DRC. You might adjust your code a bit to cover all scenarios axlSetFindFilter(?enabled `("NOALL" "DRCS") ?onButtons `("DRCS")) ; after entering next line, you must click on an error to move on mySymbol = car(axlGetSelSet(axlSingleSelectPoint())) parentList = mySymbol->violations first = car(parentList) myComponent = first->component mySymbol = myComponent->symbol myRefDes = mySymbol->refdes axlClearSelSet() 
 
 the output, after entering this line by line is shown below, as you can see, it shows the RefDes at the end.: 
 
 note: last lines can be optimiezed into this: 
 myRefDes = first->component->symbol->refdes 
 
 Visit my page

Stats

Differentiate drcs: Symbol Vs Design

Community Guidelines