Stats

  • State Not Answered
  • Replies 3
  • Subscribers 27
  • Views 9774
  • Members are here 0
More Content

how to generate Reference designator as like Capture CIS in system capture ??

kabalee

Hi everyone,

i am using System capture. i tried to use the Reference designator for the symbol  like start from U1,U2 for IC , For Resistor from R1,R2 and capacitor it should start  C1,C2.. 

but in system capture Reference Designator included Page number and other. instead of that i required as like capture CIS (17.2) even I tried using Edit--> Preference .it is not working . 

Kindly guide any one. please 

Parents
  • 0

    Check the CDS_SITE on your system. In your SITE folder go to cdssetup\projmgr\site.cpm check if you have entries such as

    REF_DES_PATTERN '($PHYS_DES_PREFIX)($PAGE)[0-9](00)'
    REFDES_ALPHA_NUM 'UNIT_NUM'
    { REFDES_ALPHA_NUM 'FULL_ALPHA' }
    REFDES_PAGE_PADDING '2'
    REF_DES_PATTERN_FIX 'ON'

    Make a copy the site.cpm file and then delete the entries from site.cpm and save the file. Close System Capture and load your design again and you should be able to see the Ref Des as U1 U2 etc.

  • 0 in reply to atishcdns

    Thanks for your update. i ll explore it and update the feedback.

    but i complete all schematic based on UXXXX . if i follow and regenerate .. it might be work right ??

    where i can find CDS_SITE  .. it is in project folder or installed location ?? please update it

Reply Children
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.