Stats

  • Locked Locked
  • Replies 9
  • Subscribers 165
  • Views 17467
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

changing only one padstack mounting hole

Fierro

Hello guys,

 What's the easiest way to change one and only one padstack from a mounting hole?. When I use Replace>Padstack it changes all mounting holes with that padstack in the board and I only need to change one. The mounting hole does not have ref des or pin number so there's no way to isolate that change into that specific hole.

I'm on Allegro v15.1

Parents
  • redwire

     Be sure to use the lower portion of the options tab that allows you to enter the reference designator, pin number and that will change just that padstack on that pin of that symbol.  

Reply
  • redwire

     Be sure to use the lower portion of the options tab that allows you to enter the reference designator, pin number and that will change just that padstack on that pin of that symbol.  

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.