Stats

Locked Locked
Replies 4
Subscribers 165
Views 13809
Members are here 0

routing diff pairs takes too long

When routing diff pairs manually, the field solver activates and runs calculations. the constraint manager modes are turned off and the DRC check is disabled. It still takes 1-2 miutes or more to start a route and every move of the mouse causes more calculations. Any way of turning off the field solver to speed up routing manually.

Parents

wolf over 17 years ago

Thank you. A fellow designer and I set this up and it works great. You are correct in that the mfg numbers for impedance are better than the Cadence numbers. I usually get close with Allegro, but not confident with it.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

wolf over 17 years ago

Thank you. A fellow designer and I set this up and it works great. You are correct in that the mfg numbers for impedance are better than the Cadence numbers. I usually get close with Allegro, but not confident with it.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.