Stats

  • Locked Locked
  • Replies 2
  • Subscribers 165
  • Views 1052
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Allegro SI - problem in creating a new DesignLink

DavidP

Hi,

I try to create a post-route simulation with 2 boards. When I create the designLink and make a "connect by component", I cannot find my connector in the list. All the models have been assigned properly. Any idea ?

David

  • Khurana

    Hmm...that's a new one!  Do you have the latest hotfix installed (what version?)?  What's the reference designator of the missing connector?

  • DavidP

    I finally fix it, it takes me some time.

    It was a bad device class for a test point. It seemed that the final connector was not seen.

    For information I run the version SPB16.01

     David

     

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.