Stats

  • Locked Locked
  • Replies 8
  • Subscribers 166
  • Views 16047
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Need Help with Allegro PCB editor 16.2

HGarcia

Hello Everybody,

I need help for a PCB that I'm routing in Allegro PCB Editor 16.2. I'm routing a BGA breakout using arcs, but these arcs have to be with a specific raidus. I tried to use arcs w/radius and the arc generated appears in etch subclass but not as a Cline, because of that I couldn't connect it to a net. Also, I tried to route using arcs but I couldn't get the specific radius what I need. Is there a way to change lines to clines? or how can I route to get a specific radius?

 Thanks a lot.

Parents
  • anniesmom1999

    http://www.youtube.com/watch?v=ujMN-_Zc2eU

    I found this in the linked video.

    After typing in set snake_enable I typed snake and tweeked the options tab.

     Thanks!

     

Reply
  • anniesmom1999

    http://www.youtube.com/watch?v=ujMN-_Zc2eU

    I found this in the linked video.

    After typing in set snake_enable I typed snake and tweeked the options tab.

     Thanks!

     

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.