Stats

  • Locked Locked
  • Replies 1
  • Subscribers 165
  • Views 13187
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Find the 90 degree routing

tonychen

hi experts,

 is there any methods or skill to check the 90 degree or the short length bend（eg. less than 3W)routing in layout?

  • Cadpro2K

    Not that I've found so far. I normally find mine when I'm previewing all the routing.

    BTW, 90 degree routing is OK. The 90 degree bend issue has been debunked time and time again. Check: www.speedingedge.com

    Good day.

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.