Stats

  • Locked Locked
  • Replies 2
  • Subscribers 164
  • Views 13107
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Auto Routing

Tanveer

 Hi,

I know this is very basic question, I have a half routed board. I want to auto rout some groups of nets step by step. it is very difficult to choose nets of the same group in the router window. can anyone please tell me how can I make groups of nets and retaining my existing routs easily.

Regards

  • oldmouldy

    Use the "Route Nets by Pick", you can then pick the nets in PCB Editor using the "Find filter" which will be a lot easier than picking the nets from the Router window.

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.