Stats

  • Locked Locked
  • Replies 3
  • Subscribers 165
  • Views 841
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[solved]noob question

sharted

Allegro/PCB Editor (16.0) does not want to auto-route my VCC and GND nets to the VCC and GND planes.  autorouter says 100%, but they arent connected.

 how do I get it to autoroute to GNDand VCC planes?

 

  • Cadpro2K

     Make sure you don't have NO_RATS property selected for the nets. If it's not set on your nets, they should route.

  • redwire

    sharted said:

     but most of the connections are low-speed and don't require my careful attention. 

     

    Heh heh...good one!  I love jokes!

  • sharted

     ^ I agree that there isn't an data signal that does not require attention.  what I am talking about is the fact that I have over 100 puldown resistors that have to connect to an external board for a bunch of unsued inputs.  they do not require my attention.

     

    ^^ thanks, norats, as well as other properties were incorrectly set.

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.