Stats

  • Locked Locked
  • Replies 1
  • Subscribers 166
  • Views 13064
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

capture does not open in win 7 64 bit

Bhuwan Sahni

 I have the OrCad 16.3 version installed on a windows 7 (64-bit) system. Just after installation everything worked fine, but suddenly Capture does not open. When I run Capture, I get to chose which version to use, the program starts up but goes straight to a minimized tray.When I click on it , nothing happens , It does not open.

What is even more strange is that any other program works, such as the PCB Designer. 

I am using win 7 home premium 64 bit and spb 16.3

Help Please???

  • steve

    Make sure you are on at least hotfix 5. Orcad was not supported on Windows 7 until that release.

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.