Package Symbol Update Path Help

 Hi All,

    Looking for some serious help here, since this one has bafled me.

My .brd file will absolutly not update the symbols 'r0603', 'c0603' that I have in a local directory (T:\pa\boards\Cadence\AllegroPCBEditor\Package).

As you can see below by the lib_symbol_path report, the SYMBOL Library shows that these symbols are being pulled form the Cadence Lib - however I've edited the env variable to exclude the cadence libraries

i.e 

SET PSMPATH = t:\pa\boards\Cadence\AllegroPCBEditor\Library\Package t:\pa\boards\Cadence\AllegroPCBEditor\Library\Mehanical t:\pa\boards\Cadence\AllegroPCBEditor\Library\Format

Set PADPATH t:\pa\boards\Cadence\AllegroPCBEditor\Library\Padstack

I've run a quick echo in the command prompt to show you the results:

Command > echo $PSMPATH
T:\pa\boards\Cadence\AllegroPCBEditor\Library\Package T:\pa\boards\Cadence\AllegroPCBEditor\Library\Mechanical T:\pa\boards\Cadence\AllegroPCBEditor\Library\Format\

Command > echo $PADPATH
T:\pa\boards\Cadence\AllegroPCBEditor\Library\Padstack\ T:\pa\boards\Cadence\AllegroPCBEditor\Library\Padstack

I've gone through and whipped out the  C:/Cadence/SPB_16.0_share_pcb_lib\symbols\ directory just in case...still when I update the symbols in the .brd file, no change.

I've verified that my r/c0603 .dra and .psm symbols are updated to what I expect in my local directory - but still no luck.

I've look at the datestamp on the the .dra and .psm files, and they look good.

Any help would be much appreciated here. Hopefully one of you can show me what I seem to be doing wrong.

-UpNorth