Stats

  • Locked Locked
  • Replies 2
  • Subscribers 164
  • Views 15405
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

problem of plotting a Schematic in Design Entry HDL?

starlin

when I  select "Fit To Page"  and use Adobe pdf printer to plot my design, the complete schematic page can not be fully displayed in one page, some of the schematic(right-bottom part) is missing, as the figure below. What's the problem? Should I change some other setting? By the way, I use cadence SPB 16.3 without any hotfix.

Parents
Reply
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.