Stats

  • Locked Locked
  • Replies 0
  • Subscribers 164
  • Views 12977
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Slide and diff pairs

Chuba

 Greetings,

 I have a situation where diff pairs are routing within the area of a BGA device in neck mode. When

the traces emerge from that area, they open up to their regular defined spacing, and then proceed

to their destination somewhere else. When I use the slide command and grab one element of the

diff pair, what happens is that the other cline immediately snaps to the neck spacing gap for the

entire length of the route. Can anyone shed any light on why this is happening?

 

 

 

 

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.