Stats

  • Locked Locked
  • Replies 9
  • Subscribers 168
  • Views 23547
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Maximum Package Height

BuddSw

I am using Allegro PCB Editor 16.3.  Although I have used this product for a while I've never needed to add Maximum Package Height as something to flag using DRC.  I've looked in the documentation and the only constraint-setting information I can find is for spacing/width/pairing type stuff.  Where can I find the documentation to set up maximum height constraints?  I know I can manually check each package on the board for it's Max Height property that is far from ideal.

 I will be grateful for any insight that can be given.

 

Budd S.

Parents
  • jd5684

    oldmouldy said:

    OK, for a keepout, Package_Height_Min is going to be 0 if you don't specify a value, that's going to be the board surface, so any parts placed within the boundary of that shape will cause a DRC. You increase the Package_Height_Min property of a Package Keepout to raise it off the board surface to allow parts with a height of less than, or equal to, the Package_Height_Min to be placed there without a DRC, parts with Package_Height_Max of greater than the Package_Height_Min of the Keepout will generate a DRC.

    I know this is an old thread, but I felt the need to say THANK YOU. There are a lot of questions answered here and other forums at a level that is nigh impossible for a beginner to understand, but this one is golden. Short, simple, and clear, this is exactly what I needed.

    Edit: Added quote for clarity

Reply
  • jd5684

    oldmouldy said:

    OK, for a keepout, Package_Height_Min is going to be 0 if you don't specify a value, that's going to be the board surface, so any parts placed within the boundary of that shape will cause a DRC. You increase the Package_Height_Min property of a Package Keepout to raise it off the board surface to allow parts with a height of less than, or equal to, the Package_Height_Min to be placed there without a DRC, parts with Package_Height_Max of greater than the Package_Height_Min of the Keepout will generate a DRC.

    I know this is an old thread, but I felt the need to say THANK YOU. There are a lot of questions answered here and other forums at a level that is nigh impossible for a beginner to understand, but this one is golden. Short, simple, and clear, this is exactly what I needed.

    Edit: Added quote for clarity

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.