Stats

  • Locked Locked
  • Replies 0
  • Subscribers 164
  • Views 12675
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Netlist issue with heterogenous part in orcad 16.5

Pankaj0K
I have heterogeneous part with six parts in a package... VCC (pin 14) and GND (pin 7) pin is being made visible to all the parts. however, in schematic design only part 1 pins are connected or wired. these pins are f type: POWER.. pin name is VCC and GND in part.

net names given to VCC and GND pins are VCC_5V and SYSGND respectively. When i generate net list,  I get two additional nets namely VCC and GND e.g.  U5.VCC and U5.GND

also there are ends VCC_5V and SYSGND connected to pin 14 and pin 7 respectively..

What could be the reason for this and how to eliminate such issue..

require immediate help...

 
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.