Stats

  • Locked Locked
  • Replies 2
  • Subscribers 165
  • Views 15680
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Layer to Layer Registration

Ron Scott

I need to clarify my fab notes and I need to know specifically which IPC document talks about layer to layer registration. I've been through the 6011 & 6012

Thanks. 

  • I don't know if this is what you're looking for but IPC-2222 Section 9.1.5 states the following: The presentation in Table 9-3 is for the tolerance to be applied to the nominal dimension chosen for the location of the lands connector contacts and conductors in relation to the datums.  This tolerance includes tolerances for master pattern accuracy, material movement, layer registration and fixturing. I've attached a jpeg of Table 9-3 to this post.

     

  • Thanks but that was not what I was looking. I did finally find the source I needed which is: IPC-6012 Rev C (Book) Paragraph: 3.4.2 Table: 3.8 Had our documentation team order book right away. Ron Scott
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.