Stats

  • Locked Locked
  • Replies 5
  • Subscribers 166
  • Views 13850
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Reg: OFFSET GRID MOVEMENT OF PARTS IN ALLEGRO16.6

girish
Hi,

In Allegro 16.6 while moving components its not jumping between grids giving smooth movement regardless of grid then after placing quickly
aligning to near by grid . Is there any setting I need to do for movement of components as it was in 16.3 ?
eg for more clarity : I have set 39.37mil grid to place same pith BGA ,but while moving BGA , its pad not picking grids showing smooth offset grid movement

Regards,
Girish Kumar
Parents
  • girish
    Oh.Then I need to wait for hotfix update Crying face.
     
    I hope below issue also related to tool bug
     
    1.While keeping the command in idle mode on PCB editor & selecting say some 10 components on linked schematic , respective parts will be highlighted on the board file .Then if I click move all highlighted parts will be moved this was happening in old 16.3 , but not working on 16.6  & then we need to manually de-highlight the parts which was temp highlighted on layout
     
    2. Swapping of components not happening between manually placed parts & imported components  throwing an error “Symbol and layer embedding requirements do not match.”
     
    Thanks for the reply . Is the any cadence source I can get  to know the reported bug ?
     
    Regards,
    Girish
Reply
  • girish
    Oh.Then I need to wait for hotfix update Crying face.
     
    I hope below issue also related to tool bug
     
    1.While keeping the command in idle mode on PCB editor & selecting say some 10 components on linked schematic , respective parts will be highlighted on the board file .Then if I click move all highlighted parts will be moved this was happening in old 16.3 , but not working on 16.6  & then we need to manually de-highlight the parts which was temp highlighted on layout
     
    2. Swapping of components not happening between manually placed parts & imported components  throwing an error “Symbol and layer embedding requirements do not match.”
     
    Thanks for the reply . Is the any cadence source I can get  to know the reported bug ?
     
    Regards,
    Girish
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.