Stats

  • Locked Locked
  • Replies 1
  • Subscribers 165
  • Views 15735
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Off Grid (Misaligned) components and circuits in Capture.

yourdreamz

I've imported a project made by OrCAD Capture 16.0 into OrCAD Capture 16.5 SPB, and all the components and wires have become misalligned to the grid. Thus it doesn't allow me to connect new components to the same. 

In my search here I found this link in this forum: www.cadence.com/.../15426.aspx

which mentions similar issue but the solution given needs lots of rework for me as different group of circuits are misaligned by different distance.  

Is there a way to solve this in a more simpler way?

  • TH Designs

    Make sure the grid setting is the same in 16.6. I recently ran into the same issue. The grid was at 1/2 in 15.7 and 1/1 in 16.5. Gave the impression that everything was off grid until I set it to 1/2 then everything lined up.

    Tom

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.