Stats

Locked Locked
Replies 2
Subscribers 165
Views 14339
Members are here 0

Set Max line width as nominal in the constraint manager.

Good afternoon,

Is there a way to set the maximum line width in the constraint manager as the "nominal"? I have a power trace with a min of 10 and max of 50. 95% of the trace will be 50. The remaining trace segments go to a test point and secondary components, which do not need to be 50. When I start the trace it always uses the 10mil setting.

Thank you,

Parents

KEN13 over 12 years ago

Thank you Mr O,
I have used neck mode on several occasions, but was still stuck in the Layout mode of min, nom, max. Simple, thanks.
Ken
Cancel
Vote Up 0 Vote Down

Cancel

Reply

KEN13 over 12 years ago

Thank you Mr O,
I have used neck mode on several occasions, but was still stuck in the Layout mode of min, nom, max. Simple, thanks.
Ken
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.