Stats

  • Locked Locked
  • Replies 9
  • Subscribers 166
  • Views 17946
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Getting part on grid

TH Designs

I just loaded a netlist into a board where the default grid is set to 0.025". None of the parts came in on this 25 mil grid.

What is the trick to getting them on grid? (I hope it is not manually as there are over 700 parts............)

Tom

Parents
  • TH Designs

    Thanks Mike. I just tried that on a smaller job I'm starting and it works well.

    I have found that eventhough quick place does not put the parts on any specific grid, once I select each part for the detailed placement, they will snap to the specified grid.

    Tom

Reply
  • TH Designs

    Thanks Mike. I just tried that on a smaller job I'm starting and it works well.

    I have found that eventhough quick place does not put the parts on any specific grid, once I select each part for the detailed placement, they will snap to the specified grid.

    Tom

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.