Stats

  • Locked Locked
  • Replies 2
  • Subscribers 164
  • Views 16390
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Model Editor Library Path Error

OldRookie

 New to the Forum and new toOrCAD 16.6 LITE.

Installed version 16.6 LITE with no warnings or errors. Capture and Pspice work well. Have created and successfully simulated several switching designs. Life is good :)

The problem comes when I try to launch Model Editor, either standalone or from within Capture. It will not launch and gives me the error message  "The library path is not configured. Please check your product installation."

I have un-installed the entire suite, rebooted, and done a full re-install three times ... I get the same error message.

An old rookie would appreciate some help from those who may have experienced this problem before.

Cheers,  John

Parents
  • oldmouldy

    Start Capture and open a PSpice project, possibly the Example from tools\pspice\capture_samples\anasim\example might be best, then use PSpice>Edit Simulation Profile, on the Configuration Files tab, select "Library" at the upper right, Library Path at the lower centre of that form is likely to be empty, it should be set to the installation path and the PSpice library location, the default would be C:\Cadence\SPB_16.6\tools\pspice\library. Give that a try as first pass.(This setting gets stored to the "pspice.ini" file in the installation.)

Reply
  • oldmouldy

    Start Capture and open a PSpice project, possibly the Example from tools\pspice\capture_samples\anasim\example might be best, then use PSpice>Edit Simulation Profile, on the Configuration Files tab, select "Library" at the upper right, Library Path at the lower centre of that form is likely to be empty, it should be set to the installation path and the PSpice library location, the default would be C:\Cadence\SPB_16.6\tools\pspice\library. Give that a try as first pass.(This setting gets stored to the "pspice.ini" file in the installation.)

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.