Stats

  • Locked Locked
  • Replies 2
  • Subscribers 163
  • Views 13621
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

At Board geometry the AST layer not get enabled?

Dhamodharann
In the Editor 16.5, at the board geometry----->Assembly Top layer is not get enabled. During the art work generation also the file is be not get enabled. the image is below. So any solution for this option. Thanks & Regards.. Dhamodharan
  • VincentS

    I see no assembly top on Board Geometry. Package Geometry and Component are the only sub classes with assembly top.

  • Dhamodharann
    Thank you vincent. I am new to pcb editor,so only.But still my doubt is whether it didn't enable it on the board geometry or it had been get disabled. Whether AST layer will been get enabled on that Package geometry and Component only???? Thanks & regards Dhamodharan
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.