Stats

  • Locked Locked
  • Replies 0
  • Subscribers 163
  • Views 14318
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cross probe issue

JohnnyWalker

Normally when you select a component or a net on the OrCAD schematic (ver 16.6), the according component or the traces will zoom-in and highlight. For some reason, my PCB Editor zooms in, but not highlighting the components/nets. Also, my current settings reverse the cross-probing. That is, I select a component in the PCB Editor and the schematic highlights the according component.

Thank you very much.

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.