Stats

  • Locked Locked
  • Replies 5
  • Subscribers 166
  • Views 12976
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

pins on a part

docb

I have a connector with pins that extend partially beyond the edge of the board. I drew the pins in the footprint on "board /geometry/assembly notes", so it would just be a visual hint in the PCB file, but no action needed by the PCB house.

I have included assembly notes in other layers when Gerbers get generated, so this is confusing.

Is there a better class I should use for this?

Parents
  • steve
    Try Package Geometry / Assembly_Top or _Bottom. This is Assembly detail not silkscreen detail. You can then create an Assembly Drawing to show the assembly house what you want.
Reply
  • steve
    Try Package Geometry / Assembly_Top or _Bottom. This is Assembly detail not silkscreen detail. You can then create an Assembly Drawing to show the assembly house what you want.
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.