Stats

  • Locked Locked
  • Replies 9
  • Subscribers 168
  • Views 14710
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Gerber does not agree with allegro dimension. Everything is shifted

TiBo

Hi,

I haven't seen this or ever been mentioned to me that the gerber does not agree with my allegro dimension.

Anybody sees this kind of problem before and what is your solution for this.

I have Allegro 16.6 - hotfix 67 which is the latest. I use CAM350 to verify the off set and the board vendor also told me so.

Thank in advance.

Regards,

TiBo

Parents
  • oldmouldy
    You could also check the Scale Factor for Output in the Parameters tab, a bit unlikely that you would have touched this though. A mix of metric / English units might be a consideration as well but unlikely...
Reply
  • oldmouldy
    You could also check the Scale Factor for Output in the Parameters tab, a bit unlikely that you would have touched this though. A mix of metric / English units might be a consideration as well but unlikely...
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.