Stats

  • Locked Locked
  • Replies 6
  • Subscribers 169
  • Views 17569
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot create pad shape with void in the middle

mitch21

Hi!

We're trying to create a padstack with voids like the following part (the outer large pad)

 

We get this error: "shape symbol cannot have a void in a shape".  Unfortunately we can't do like in some of the online helps to make a small cut in the copper, as this is a microphone seal and we need good solder all around.

How would we go about making this pad in the shape editor?

Thanks,

Mitch

Parents
  • aricbeaver
    But it seems like it is limited to circles only
Reply
  • aricbeaver
    But it seems like it is limited to circles only
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.