Stats

  • Locked Locked
  • Replies 2
  • Subscribers 167
  • Views 1001
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Area arround pin- PCB designer

KrzysztofB

Hello Everyone,

I have problem with pins that I used as mounting holes.

Some addidional copper void area is arround and I do not want it.

That component is not only mechanical pin, because I have added
it to schematic and grounded. 

Where I can find option to make that void area disabled?

I am using PCB Designer Professional 16.6.

Best regards,

Chris

Parents

  • You could also have a Route Keepout shape as part of the symbol. Open the filename.dra (mechanical symbol) and make sure all the layers are turned on, you should see a copper rectangular shape on Route_Keepout/All. Delete this and then save the symbol and refresh it in the design.

Reply

  • You could also have a Route Keepout shape as part of the symbol. Open the filename.dra (mechanical symbol) and make sure all the layers are turned on, you should see a copper rectangular shape on Route_Keepout/All. Delete this and then save the symbol and refresh it in the design.

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.