Stats

  • Locked Locked
  • Replies 2
  • Subscribers 165
  • Views 14986
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Allegro PCB editor; Auto rename refdes issue.

domsmac

HI,

My issue is that when I run a Automatic rename refdes, a few parts are left out from being updated.
These parts keep their refdes, the other parts are updated, no duplicate of refdes.

I have checked properties, and these parts do not have "hard_location" properties set or alike.

To me, it looks like there is a part of the board that is not included when renamed.
(If I move the part to a different location on the board, it is included when renamed)


What and how can this be?
How do I change it?

Best Regards,

Martin.

Parents
  • domsmac
    Hi Mike,
    Thanks for you input.
    I think my issue was due to a defined Window...
    I tried Logic -> Auto Rename Refdes> Design (rename area design) and it worked..

    Thanks for your help.
    /Martin.
Reply
  • domsmac
    Hi Mike,
    Thanks for you input.
    I think my issue was due to a defined Window...
    I tried Logic -> Auto Rename Refdes> Design (rename area design) and it worked..

    Thanks for your help.
    /Martin.
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.