Stats

  • Locked Locked
  • Replies 4
  • Subscribers 166
  • Views 2237
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Reduce clearances/thermal relief between shapes and clines

Fras

Hello,

I'm using allegro 16.6 and I'm having some difficulty with clearances between certain shapes:

From my screenshot, I'm trying to connect all the areas in red together (they are all RXGND). Is there something I should be using such as global parameters or some box i need to tick for these smd pads to be covered?

Cheers, 

Fraser 

Parents
  • Dale Peterson

    Fraser,

    I see your DRC's but, what's the violation.  What does it say when you click on the DRC mark and do " Show Element". I notice that you have 2 pads real close together around these DRC's. Are they on the same net? If so, you may need to set  the Same net spacing for SMD Pins to SMD Pins to something smaller. 

    Cheers

    Dale

Reply
  • Dale Peterson

    Fraser,

    I see your DRC's but, what's the violation.  What does it say when you click on the DRC mark and do " Show Element". I notice that you have 2 pads real close together around these DRC's. Are they on the same net? If so, you may need to set  the Same net spacing for SMD Pins to SMD Pins to something smaller. 

    Cheers

    Dale

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.