Stats

  • Locked Locked
  • Replies 16
  • Subscribers 166
  • Views 21864
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PCB Editor Immediately AutoSaving and Closing When Opening Design

melview1

I've got an installation of PCB Editor that will open a design, but then will immediately auto-save and close.  Immediately after loading the design, it says
Auto saving before quitting, please wait...." and then closes.  I don't see any error messages and it doesn't seem to be crashing.  It's just Auto-Saving.  An AUTOSAVE.BRD file is created.  Weirdly, if I go into User Preferences-->File_Management-->Autosave, the autosave option is not checked.

It happens on multiple designs, some that have previously worked.  It seems a bit random.  My workaround has been to keep opening other designs until I get one that stays up, then I can go to recently opened designs menu and open the previously shutting down design without issue.

This was happening on my v17.2 S001 installation, so yesterday, I updated to S038, hoping it would solve the problem.  The first design I opened had no issue, so I thought I was good to go.  However today, I tried to open that same design and it encountered this issue.  I then found a design that opened and used my workaround.  As a test, I closed the problem design and opened the one that just got me in again and that design encountered the issue.  I'm at a bit of a loss as to what's going on.  Does anyone have any suggestions or troubleshooting I can go through?

Thanks.

--Mark

Parents
  • steve

    Locate your HOME directory (so type %HOME% into the address bar of Windows explorer). In here is a pcbenv folder, rename this to pcbenv_old then try and run the tools again. if this solves your issue you will need to redefine your setup (so padpath, psmpath etc) and any shortcut keys you may have. If it doesn't post back

  • melview1
    in reply to steve

    Moments after my last reply, it went south with the new pcbenv folder.  Any other suggestions?

  • mcatramb91
    in reply to melview1

    I know it is a little extreme, but could you try renaming the 17.2 folder (RMB > Rename) in the registry and restart the PCB Editor.  PCBENV Folder is not the only place were the configuration is stored, data is also in the Registry.  Renaming the folder will allow it to regenerate a clean registry folder.

    Worth a shot.

    Registry location: HKEY_CURRENT_USER \ SOFTWARE \ Cadence Design Systems \ 17.2

Reply
  • mcatramb91
    in reply to melview1

    I know it is a little extreme, but could you try renaming the 17.2 folder (RMB > Rename) in the registry and restart the PCB Editor.  PCBENV Folder is not the only place were the configuration is stored, data is also in the Registry.  Renaming the folder will allow it to regenerate a clean registry folder.

    Worth a shot.

    Registry location: HKEY_CURRENT_USER \ SOFTWARE \ Cadence Design Systems \ 17.2

Children
  • melview1
    in reply to mcatramb91

    I tried your registry fix and the pcbenv rename together.  I'll give it some time and report back.

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.