Stats

  • Locked Locked
  • Replies 3
  • Subscribers 163
  • Views 13451
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Model Selector question

tltoth

Hi,

Is there a way to invoke model selector during SI model device assignment in Capture?
It assigns using the first available model of the component.

Thanks

Parents
  • Alok Tripathi

    Have you tried Right Mouse Button - Si Analysis - Assign SI Model ?

Reply
  • Alok Tripathi

    Have you tried Right Mouse Button - Si Analysis - Assign SI Model ?

Children
  • tltoth
    in reply to Alok Tripathi

    Thanks alokt,

    I was refering to [Model Selector] keyword in the IBIS standard.
    When the component model contains more than one vesion inside the ibis file i.e. 1.8V 2.5V 3.3V the assingnment is always done using the first one (here 1.8V)

  • Alok Tripathi
    in reply to tltoth

    Ohhh, OK. I am not aware of such control. 

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.