Stats

  • Locked Locked
  • Replies 0
  • Subscribers 164
  • Views 1295
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Quickplace - place components by room

adomino

Hello, I am trying to use rooms to place components on my board. I created a "power" room in the schematic and generated a new netlist. I imported the new netlist and placed my "power" room in pcb editor. Then I went to place --> quickplace and selected place by room. But the drop down that should show all my rooms is empty so I am not able to place the components.

I also tried selecting "place all components" using quickplace, but the viewlog says "placed 0 out of 0 applicable (0 total) symbols". Any ideas on why quickplace is not working?

Thanks!

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.