Stats

Locked Locked
Replies 2
Subscribers 166
Views 15435
Members are here 0

Mechanical Hole to Dynamic Shape Spacing

I have a copper pour(dynamic shape) around a non plate through mechanical hole that is always 20mils regardless of the Hole to Shape setting in the constraint manager. There is a property in the hole that I can set to reduce the spacing but I would think this should be able to be done globally through the constraint manager. I also did a force update between setting changes.

The hole has no keep outs. Is there a setting in the constraint manager I am missing?

(Allegro 17.2 with the latest hotfix)

redwire over 6 years ago

Can't see your board but dynamic shapes to mech holes will follow the MECH_PIN_TO_CONDUCTOR_SPACING rule that is in Constraint Manager->Analyze->Analysis Modes

Once in that menu, it's under Design->Mechanical Spacing->Mechanical Drill to Conductor Spacing
Cancel
Vote Up +1 Vote Down

Cancel
VinCT over 6 years ago in reply to redwire

Thanks, found it. Appreciate your input.
Cancel
Vote Up 0 Vote Down

Cancel

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.