Duplicate user-defined property in pstxprt.dat

Hello,

I use OrCAD Capture and I modified the allegro.cfg to add a user-defined property in the [ComponentInstanceProps] section.  I expected my user-defined property to appear under the SECTION area, but it is appearing immediately under the PART_NAME area and SECTION area.

Is this expected behavior?

allegro.cfg

[ComponentInstanceProps]
BOM=YES
GROUP=YES
ROOM=YES
VOLTAGE=YES
SIGNAL_MODEL=YES
NO_XNET_CONNECTION=YES

pstxprt.dat

PART_NAME
A5 'MIS-000027':
BOM='ANT_CHIP';

SECTION_NUMBER 1
'@BLE_SENSOR.SCHEMATIC1(SCH_1):INS16746785@BLE_SENSOR.2450AT18D0100E_0.NORMAL(CHIPS)':
C_PATH='@ble_sensor.schematic1(sch_1):ins16746785@ble_sensor.\2450at18d0100e_0.normal\(chips)',
P_PATH='@ble_sensor.schematic1(sch_1):page3_ins16746785@ble_sensor.\2450at18d0100e_0.normal\(chips)',
BOM='ANT_CHIP',
PRIM_FILE='.\pstchip.dat',
SECTION='';