Stats

  • Locked Locked
  • Replies 1
  • Subscribers 166
  • Views 12422
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Netlist error

MightyBeard7

I am using Allegro 16.6V. I am trying to enter two separate pages of schematic under a single schematic folder. I need to create a single netlist and I need to have reference designators of each page to begin at Number 1.

Can somebody tell me the steps I need to follow?

Thanks In advance

  • You can try but PCB Editor is unlikely to accept the resulting netlist because you will, most likely, have duplicated reference designators for parts on the two pages. PCB tools aren't going to accept this since they are inherently "flat" when it comes to component referencing.

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.