Stats

  • Locked Locked
  • Replies 0
  • Subscribers 165
  • Views 12833
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Font and Font size on symbols not carried over to schematic capture

4ricktan

Is there a way to get OrCAD Capture to display a symbol exactly as it was created, complete with the font and font sizes used during symbol creation?

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.