Stats

  • Locked Locked
  • Replies 1
  • Subscribers 163
  • Views 21489
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How do I turn off snap to grid in PCB Designer

davismeissner

Quick Question, I can not figure out how to turn off snap to grid when placing components manually in PCB Designer. I am trying to align ann external connection component to the PCB edge but it either sticks out too far or is too far back on PCB. 

THANK YOU

  • davismeissner

    Found it go to Setup -> Grids -> Then make the spacings smaller

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.