Stats

  • Locked Locked
  • Replies 0
  • Subscribers 164
  • Views 13387
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Symbol Import issue in OrCAD capture CIS 17.4

SPTT

Hello Everyone ,

I am using OrCAD capture CIS 17.4 Eval to design a controller board . This is my first time working with OrCAD capture CIS and I am facing a symbol import issue .

When I try to import a Symbol from Ultra Librarian the import process goes on smoothly by following the import guide from UltraLibrarian but when I try to use it in my schematic the pins of the symbol all group to the left side . I don't see this grouping when I import the library for the first time and look at the symbol but after placing the symbol on my schematic this grouping of pins on one side is reflected even in the library. I spent countless hours looking online if anyone faced a similar issue but couldn't find a relevant discussion . Hence , my post. 

I have pasted a screenshot of the issue below :

Thank you for your time and I look forward to any suggestions ,

Best,

SP

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.